Library 路 Brain Chemistry

Orexin Fade 馃寵

For When You're Exhausted and Still Wide Awake 路 12 hours

For when you're exhausted and still wide awake.

Orexin Fade, For When You're Exhausted and Still Wide Awake
Listen free on YouTube Download the full night 路 $5

How do you make a sound disappear without anyone noticing it's gone?

That was the problem with this one.

Orexin is the signal in your brain that keeps you awake. It's supposed to stand down at night, and for a lot of us it just doesn't. You're exhausted, you've done everything right, and you're still lying there completely alert. Narcolepsy is what happens when people lose orexin entirely, so chronic insomnia is a bit like the mirror image of it. The switch is stuck on.

I wanted to build something that behaved like that signal letting go. Which meant the sound itself had to leave.

The obvious way is to just fade a layer out, but I've done that before and it draws attention to itself. You notice the moment it ends. So I tried something different.

How I Built It

The Dimming Tone

A soft sustained tone, tuned to sit exactly on top of the pulse underneath it so the two read as one sound rather than two. Instead of fading it out, I slowly filtered the brightness off it. Over the first forty minutes it gradually loses its upper harmonics, getting darker and duller rather than quieter, until there's nothing left to hear. It doesn't end. It dims.

The Steady Floor

Underneath, a smooth blend of brown and pink noise, kept deliberately neutral. No boosted bass, no bright top end, nothing shaped to draw the ear. Its whole job is to still be there when the tone has gone.

Most of the work went into the filter curve. A straight linear sweep spends most of its time up in the frequencies you can barely hear, then drops audibly right at the end, which is exactly the thing I was trying to avoid. Curving it properly spreads the dimming evenly across the whole forty minutes, so there's never a moment you could point at.

I also kept the noise bed as plain as I could. There's a temptation to make every layer interesting, but if the floor is doing something the ceiling can't quietly leave.

I'm happy with how this one turned out. It starts as a soundscape and ends as a noise, and I don't think you can hear it happen.

The Isochronic Layer

A slow pulse descending through the first 45 minutes, then holding:

0:00 路 The Signal 路 11 to 8 Hz
Starting higher than usual, because at this point the wake signal is still running.
15:00 路 Standing Down 路 8 to 4 Hz
Down through theta toward the edge of delta.
45:00 路 Dark 路 Steady 4 Hz
Completely stable for the remaining eleven hours. No drift, no phases, nothing changes. If you surface at 3am it will be exactly where you left it.

The carrier sits low at 110 Hz throughout and the pulse is mixed quietly. It's meant to be felt rather than heard.

What Are Isochronic Tones?

Isochronic tones are rhythmic pulses of sound at a precise frequency. Heard consistently, the brain's own rhythms can begin to sync toward them, a process called entrainment.

Unlike binaural beats they don't need headphones. The pulse exists in the sound itself rather than between your two ears, so speakers work just as well.

Use This For

馃寵 Lying awake exhausted and unable to drop off
馃寵 Stress-driven insomnia and a mind that won't stand down
馃寵 Waking in the night and struggling to get back
馃寵 Wind-down before bed
馃寵 Nervous system regulation and deep rest
馃寵 Shift work and daytime sleeping

How to Listen

馃攰 Comfortable volume, not loud
馃帶 Headphones or speakers both work, no binaural layer here

If you've been lying awake wide-eyed and tired at the same time, try this one quietly tonight and see what you make of it.

Sleep well, my friends.

MADE USING: Sustained harmonic pad tuned to A minor, logarithmic low-pass filtering, smoothed brown and pink noise, isochronic modulation at a 110 Hz carrier, spectral balancing and level matching.