I'm much more of a shower person, and it had been ages since I'd had a proper bath. I'd forgotten how good a long, hot soak could be.
This one is for the nights your whole body feels tight and tired, and all you want is to sink.
I wanted it to feel like lowering yourself into a hot magnesium bath and letting your ears slip under the water, where everything goes dark, close and warm. So I pushed the brown noise deep, rounded the top right off, and gave it the slightly hollow colour a tub makes when you're under. For the first twenty minutes it moves like a bath being filled, then the water goes completely still. Somewhere far off, the house hums faintly through the water. There's no magnesium in a sound, of course. It's the feeling of the soak I was after.
What you'll hear in Magnesium Bath
🛁 Deep, warm brown noise, heard the way you hear the world from under the water
🌊 A slow swell for the first twenty minutes, like the tub filling, then total stillness
🏠 A faint, far-off boiler hum through the water
🫧 A soft, hollow colour, close and enclosed, with no hiss
〰️ After the swell fades, one steady sound to the last minute. No music, no splashing
How It's Made
If you're curious, here's what's going on under the hood.
- The bed: close to full brown noise, a low shelf lifted 9 dB below 100 Hz and a broad 6 dB warmth band around 200 Hz for the heavy, warm-water body. A slight lift at 350 Hz helps it carry on small speakers.
- Under the water: the top is rolled off from 600 Hz and the hiss is shelved down a further 12 dB from 3 kHz.
- The tub: a narrow 2 dB lift at 450 Hz gives the hollow colour of a bath heard from below the surface.
- The bottom: a low cut at 30 Hz and a steep cut at 25 Hz clear out rumble that's too low to hear.
- Filling the tub: for twenty minutes the bed swells gently darker every 18 seconds, fading out between minutes 12 and 20, while it opens from half width to full over 15 minutes, like the water closing around you. Then nothing moves again.
- The house: a steady hum at 40 Hz, with overtones at 80 and 120 Hz, filtered above 250 Hz so it sounds far away. Its pitches sit clear of the 95 Hz pulse, so the two never beat.
- Tape warmth: analogue-style saturation adds density and rounds off the edges.
- The bathroom: a small, heavily damped reverb, the room as you'd hear it from under the surface.
- A layered opening: noise first, the hum at three seconds, the pulse at six, so you hear the sound build.
- A clean pulse: the isochronic tone is mixed after all the processing, so nothing smears the rhythm, and every change is a smooth ramp.
The Isochronic Layer
- 0:00 · Lower in (6 to 4 Hz)
- A soft, rounded pulse in the drowsy theta range, easing slower while the tub fills.
- 20:00 · Sink (4 to 2 Hz)
- The water goes still and the pulse keeps slowing, down into the delta range.
- 1:05:00 · Soak (Steady 2 Hz)
- From here nothing changes, all the way to morning.
The carrier tone sits at 95 Hz, inside the noise and mixed to be felt rather than heard.
What Are Isochronic Tones?
Isochronic tones are rhythmic pulses of sound played at a precise frequency. Heard consistently, the brain's own rhythms can begin to sync toward them, a process called entrainment.
Unlike binaural beats, they don't need headphones. The pulse exists in the sound itself rather than between your two ears, so speakers work too.
Use This For
🛁 Nights when your whole body feels tight and tired
🌊 When all you want is to sink and let everything go heavy
😴 Falling asleep to something warm, dark and enveloping
🌙 Anyone who sleeps best with one deep, steady sound all night
How to Listen
🔈 Keep the volume low to moderate. It still feels heavy when quiet
🎧 Headphones, earbuds or a good speaker carry the low end best. Phone speakers lose a lot of the bass, so it will sound thinner there
If You Liked This One
Hibernation Mode is the dry, still version, tucked deep underground while the winter goes on above you:
Hibernation Mode
Weighted Sleep Noise puts the weight in the low middle, close and wrapped around you:
Weighted Sleep Noise



